USER’S MANUAL Single Sofa Chair THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Contact Us! Do NOT return this item. Contact our friendly customer service department for help first. E-mail cs@gymaxservice.com Before You Start Read each step carefully before starting. It is very important to ensure each step followed in correct order, otherwise assembly difficulties may occur. Most of board parts are labeled or stamped on the raw edges. Have a check to make sure all parts are included. Work in a spacious area, preferably on a carpet close to where the unit will be used.
WARNING product for safety reasons. IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
HARDWARE B Threaded Rod M8 x 70mm QTY 6 PCS A Spanner mm PC QTY C Nut M8 QTY 6 PCS D Washer M8 x 22mm QTY 6 PCS 04 E Spring Washer M8 QTY 6 PCS
Carefully unpack parts/hardware from box and storage of seat body, place on a clean flat surface.
2 Screw in three threaded rods into pre-drilled holes of armrest by hand until about half of the thread is exposed. Repeat steps for other armrest.
3 Locate pre-drilled holes on the side of sofa body and match the orientation with the correct armrest. body by aligning and going through the three pre-drilled holes at the side of sofa body. Open compartment cover underneath the sofa base and secure all three threaded rods with flat washers, spring washers and nuts from inside with spanner, making sure there is no movement. Repeat step for other armrest.
4 Align all four legs onto pre-drilled holes and secure by hand. Please avoid overtightening. 6 3 6 3 6 6 Insert backrest metal plates to both arms as shown below. Ensuring it is correctly in place.
6 Secure both back cushions by locating the zipper end. Fasten both sides and continue all the way to the end. Flip the pillow into position when finished. Place accent pillows as desired .
INSTALLATION COMPLETE 10
Care and Maintenance Use a soft, clean cloth that will not scratch the surface when dusting. Use of furniture polish is not necessary. Should you choose to use polish, test first in an inconspicuous area. Using solvents of any kind on your furniture may damage the finish. Never use water to clean your furniture as it may cause damage to the finish. Liquid spills should be removed immediately. Using a soft clean cloth, blot the spill gently. Avoid rubbing.
