USER’S MANUAL Rattan Sun Lounger THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Contact our friendly customer service department for help first. cs@gymaxservice.com Read each step carefully before starting. It is very important to ensure each step followed in correct order, otherwise assembly difficulties may occur. Most of board parts are labeled or stamped on the raw edges. Have a check to make sure all parts are included. Work in a spacious area, preferably on a carpet close to where the unit will be used. Keep the hand tools close at hand.
L D H K J G I B C E A F Notice: 1. 50% Tighten before fixing all screws, Allen wrench is recommended instead of an electric drill. 2. Place the item on a flat ground to adjust and make sure it remains stable 3. Tighten up all screws with tools gradually. If the screws are not aligned with holes during assembly, please loosen all the other screws to 50% and continue the assembly process. 5.
Part & Hardware List A B Right Frame (1pc) D C Left Frame (1pc) E Side Left Frame (1pc) G F Front Frame (1pc) H I K Left Arm (1pc) 1 Seat Cushion (1pc) Bolt M6 x 20 mm (2 pcs) Pillow (1pc) 3 Bolt M6 x 30 mm (12 pcs) 5 Bolt M6 x 55 mm (2 pcs) Right Arm (1pc) L 2 4 Seat Frame (1pc) Back Frame (1pc) Back side Frame (1pc) J Side Right Frame (1pc) Bolt M6 x 40 mm (8 pcs) 6 M6x1 Washers (24 pcs) 4 Allen key M4 (2 pc)
STEP 1 STEP 2 Connect Left Frame (B) & Side Left Frame (D) with Bolt (2) & Washers (5) Connect Right Frame (A) & Side Right Frame (C) with Bolt (2) & Washers (5) 2 2 C D B A STEP 3 Connect part from STEP 1 & Front Frame (E) & Back side Frame (G) with Bolt (2) & Washers (5) 2 G 2 E 5
STEP 4 Connect part from STEP 2 & STEP 3 with Bolt (2) & Washers (5) 2 2 STEP 5 Connect part from STEP 4 & Seat Frame (F) with Bolt (2), (3) & Washers (5) F 3 3 3 3 3 2 2 3 6
STEP 6 Connect part from STEP 5 & Back Frame (H) with Bolt (1) & Washers (5) 1 H 1 STEP 7 Connect part from STEP 6 & Left Arm (J) with Bolt (2), (3), (4) & Washers (5) J 4 3 2 7
STEP 8 Connect part from STEP 7 & Right Arm (I) with Bolt (2), (3), (4) & Washers (5) 4 3 2 I STEP 9 Backrest tilt angle can be adjusted 8
STEP 10 Put on Seat Cushion (K) & Pillow (L) to Complete Sun lounger L K STEP 11 FINISH 9
