Instructions/Assembly Guide

CROSSMEMBER ATTACHMENT
GYM RAX® INSTALLATION | STORAGE & SUSPENSION SYSTEMS 8 REVISON 21A
STEP 1B – ASSEMBLE REMAINING POSTS
A) Assemble remaining Posts to Anchor Plates using the procedure in Step 1A.
B) Add-on additional 48” 1/8” apart on centers.
C) Line up the rear edge as shown.
D) Anchor Plates require a firm, flat and level ground surface. The Posts should be stable
and not teeter fore-aft or side to side. Check the ground surface and ensure no debris
is under the plate and the ground surface is flat and level.
REAR EDGE
MULTIBAY
ADD-ON
POSTS