Instructions/Assembly Guide

POST ASSEMBLY
GYM RAX® INSTALLATION | STORAGE & SUSPENSION SYSTEMS 7 REVISON 21A
INSTALL PROCEDURE
STEP 1A – POST/ANCHOR PLATE ASSEMBLY
A) Set the Anchor Plates AP on the ground near the position where the storage bay will rest.
Set plates apart 44 1/8” on centers. Keep enough space off the wall to fasten the rear
screw. It will be possible to slide the storage bay before adding Rax and items.
B) Lift a Post P3 P4 P6 to vertical. PositIon the Post with Rax slots facing forward and the low
side hole facing inward. If the low side hole is facing outward, flip the post end over end
and the low side hole will be facing inward.
C) Lower the Post over the tabs protruding from the Anchor Plate until the Post is resting on
the plate and the holes line up. The rear tab will be on the outside of the Post while the
other tabs will be on the inside of the post.
D) Using two M10 Hex Head Screws H1, lightly tighten a screw through the side hole and
then another screw into the rear hole. Fully tighten both screws with a 6mm Allen key.
LOW SIDE HOLE
FACES INWARD
BOTH SIDES
REAR TAB IS ON
OUTSIDE OF POST