Instructions/Assembly Guide

CROSSMEMBER ATTACHMENT
GYM RAX® INSTALLATION | STORAGE & SUSPENSION SYSTEMS 12 REVISON 21A
STEP 2C – FINAL PLACEMENT AND CHECKS
A) Carefully slide the assembled Post-Crossmember structure into the desired placement.
The rear Anchor Plates should be 0.5”-2.0” from the wall. Move each post a small
amount at a time.
B) Square the structure by adjusting the Anchor Plates so they are parallel and
perpendicular to the wall.
C) Check to make sure the Anchor Plates are firmly set on the ground and are not
teetering. Adjust as necessary.
D) The stability of the structure will increase with the addition of Rax Attachment and load
on the system.