Instructions/Assembly Guide

CROSSMEMBER ATTACHMENT
GYM RAX® INSTALLATION | STORAGE & SUSPENSION SYSTEMS 9 REVISON 21A
STEP 2A –CROSSMEMBER ATTACHMENT
A) Connect two Posts with the Crossmember CM using 6 M10 screws H1 and 2 M10 Nuts
H2.
B) Start by placing a screw in position 1 on each post and lightly tighten. Next, add a
screw in position 2 on each post and lightly tighten.
C) Add a screw in position 3 with a nut on the inside of the post.
NOTE: The screw at position 3 is only used on the base bay and not on add-on bays.
D) Fully tighten all screws on Crossmember using a 6 mm Allen key and 17 mm wrench.
E) Insert the End Cap EC at the top of each post.
REAR SIDE