Instructions / Assembly

`
Fit the hose to the appliance using a spanner to tighten it onto the connection thread. If the hose is replaced
it must be secured to the appliance and regulator connections with hose clips. Disconnect the regulator from
the cylinder (according to the directions supplied with the regulator) when the barbecue is not in use.
The Barbecue must be used in a well ventilated area. Do not obstruct the flow of combustion air to the
burner when the barbecue is in use. ONLY USE THIS BARBECUE OUTDOORS.
BEFORE USE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3 parts water.
Ensure the control valve is “OFF”.
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are secure
then turn ON the gas.
Brush the soapy solution onto the hose and all joints. If bubbles appear you have a leak, which must be
rectified before use.
Retest after fixing the fault
Turn OFF the gas at the cylinder after testing.
If leakage is detected and cannot be rectified. Do not attempt to cure leakage but consult your gas dealer.
Lighting Instructions for beefer grill
1. Read and follow the operator’s instructions in owner’s manual before lighting.
2. Make sure the control knobs are in OFF position,open gas bottle valve according to instructions.
3. Push the knob and turn anti-clockwise to the “MIN” position,this will light the burner.
If not repeat this process.
4. Adjust the heat by turning the knob to the MAX/MIN position.
5. To turn the beefer grill OFF . Turn the cylinder valve or regulator switch to the “OFF” position and then
Turn the control knob on the appliance clockwise to the OFF position.
Put 1.5V battery inside before light.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve off.
Wait five minutes before attempting to relight with ignition sequence.
Clean your barbecue after each USE. DO NOT use abrasive or flammable cleaners, as it will damage the
parts of the product and may start a fire. Clean in warm soapy water.
WARNING: Accessible parts may be very hot. Keep young children away from the hot appliance at all times
(even while cooling down!).