Instructions / Assembly
`
The hose should be secured to the regulator and the appliance with hose clips. Make sure the flexible hose
could not come in contact with hot surface and avoid twisting.
Use a suitable regulator that is certified to BSEN 12864 or EN 16129. Make sure the regulator and
flexible hose comply with local code.
Please consult your LPG dealer for information regarding a suitable regulator for the gas cylinder.
Regulator and Hose
Use only regulators and hose approved for LP Gas at the above pressures. The life expectancy of the
regulator is estimated as 2 years.
The use of the wrong regulator or hose is unsafe; always check that you have the correct items before
operating the barbecue.
The hose used must conform to the relevant standard for the country of use. Worn or damaged hose must be
replaced. Ensure that the hose is not obstructed, kinked, or in contact with any part
of the barbecue other than at its connection.
For Flexible hose:
Avoid twisting the flexible tube when the appliance is in use. The length of flexible hose shall
not exceed 1.5m. In Finland, the length shall not exceed 1.2m. The hose should certified
according to applicable EN Standard and comply with local code.
Gas Cylinder
The gas cylinder should not be dropped or handled roughly! If the appliance is not in use, the cylinder must
be disconnected. Replace the protective cap on the cylinder after disconnecting the cylinder from the
appliance.
Always connect or replace the cylinder in a well-ventilated area and away from any source of
ignition, never in the presence of a flame, spark or heat source.
Cylinders must be stored outdoors in an upright position and out of the reach of children. The cylinder must
never be stored where temperatures can reach over 50C. Do not store the cylinder near flames, pilot lights
or other sources of ignition. DO NOT SMOKE.
This barbecue is designed for use outdoors, away from any flammable materials. It
is important that there are no overhead obstructions and that there is a minimum
distance of 122cm from the side or rear of the appliance. It is important that the
ventilation openings of the appliance are not obstructed. The barbecue must be
used on a level, stable surface. The appliance should be protected from direct draughts and shall be
positioned or protected against direct penetration by any trickling water (e.g. rain).
Make sure that the gas cylinder compartment (if any) is not obstructed, keep it ventilated and clean.
Parts sealed by the manufacturer or his agent must not be altered by the user. No modifications
should be made to any part of this barbecue and repairs and maintenance should only be carried out
by a CORGI registered service engineer.
Connection to Appliance
Before connection, ensure that there is no debris caught in the head of the gas cylinder, regulator, burner
and burner ports. Spiders and insects can nest within and clog the burner/venturi tube at the orifice. A
clogged burner can lead to a fire beneath the appliance.
Clean burner holes with a heavy-duty pipe cleaner.