User manual

16
C. Plug power cord into the power outlet.
D. Set Power switch to “ON” position.
E. Adjust “Voltage” and “Current” control to the desired output voltage and current.
F. Connect the external load to the output binding posts. Make sure both “+” and “-” terminals are connected
correctly.
6-5. Remote Error Sensing
A normal power supply can perform its best load regulation, line regulation, low output impedance, and low output
ripple and noise, as well as the rapidly transient recovery response. Please refer to figure 6-2. If there is any test lead
connected between load and output terminal, the best characters of power supply can not be shown up on the load
terminal.
Figure 6-2 The power supply with local error sensing