Datasheet

#1 (+3.3V)
#2 (+5V)
#3 (+15V)
#4 (-15V)
PSW
PSW
PSW
PSW
#1 ON/OFFPSW
t
1on
t
2on
t
3on
t
4on
t
1off
t
2off
t
3off
t
4off
F.
OUTPUT ON /OFF DELAY
The output On/Off delay feature enables the setting of a specific time
delay for output on after the power supply output is turned on, and a
specific time delay for output off after the power supply output is
turned off. When multiple PSW units are used, the On/Off delay time
of each unit can be set respectively referring to fix time points.
This multiple-output control can be done through the Analog
Control terminal at the rear panel or through the PC programming
with standard commands.
The Example of Output On/Off Delay Control Among Multiple Outputs of the PSW Units
G.
VARIOUS INTERFACES SUPPORT & EXTENDED TERMINAL BOX
E.
SERIES AND PARALLEL CONNECTIONS
To increase power output capacity, the PSW-Series could be connected
in Series mode to perform double voltage rating or in parallel mode to
perform triple current rating for each model. With Multi-Range feature
and Series/Parallel connection capability, the PSW-Series is a high power
density and cost-effective equipment for the tests of DC power modules,
batteries and components in a broad power range.
Series Connection
Parallel Connection
Parallel Connection
Master
unit
Slave
unit 1
Slave
unit 2
Master
unit
Slave
unit 1
Slave
unit 2
PSW 250V/800V only support parallel connections
and maximum units in parallel is three.
(for PSW 250V/800V)(for PSW 30V/80V/160V)
GUG-001
GPIB to USB Adapter
GET-001
Extended Terminal
GET-002
Extended Terminal
An Extender Terminal box (P/N: GET-001/GET-002) is provided as
optional accessory to extend the power output form the rear panel
to the front side. This extender terminal gives R&D or QC engineers
convenience to do the jobs without frequently reaching the output
terminal at the rear side of the PSW-Series.
Rear Panel for PSW-Series
Analog Control
Connector
USB Interface for
Remote Control
Output Terminal
(for High Voltage)
Output Terminal
(for Low Voltage)
LAN Port for System Communication
The PSW-Series provides USB Host port in the front panel for easy
access of stored data, such as test script program. In the rear panel,
a USB Device port is available for remote control or I & V data
logging of power output through a PC controller. The LAN interface,
which meets DHCP standard, is provided as a standard feature of
the PSW-Series for system communications and ATE applications.