User manual

CONFIGURATION
93
USB/GPIB Settings
Front Panel USB
State
Displays the front panel USB-A port state. This
setting is not configurable.
F-20
0 = Absent, 1 = Mass Storage
Rear Panel USB
State
Displays the rear panel USB-B port state. This
setting is not configurable.
F-21
0 = Absent, 2 = USB-CDC,
3 = GPIB-USB adapter
Rear Panel USB
Mode
Sets the rear panel USB mode.
Note: Option #3, USB CDC Full Speed Only,
can be used to reduce the data transmission
speed when there are sources of interference in
the operating environment. This option is only
available for firmware version 1.42 and above.
F-22
0 = Disable, 1 = GPIB-USB
adapter (for GUG-001),
2 = USB CDC. 3 = USB CDC Full
Speed Only
GPIB Address
Sets the GPIB address.
F-23
0~30