User Manual

MSO-2000E & 2000EA User Manual

136

LIN Serial Bus Interface

The local interconnect network (LIN) bus is a single wire interface.

Panel operation

1. Connect the bus signal (LIN Input) to one of the

oscilloscope’s analog or digital channels.

Connect the ground potential to one of the

probes’ ground clip if you are using the analog

channels or to the ground connector of the

Digital card if you are the using digital

channels.

LIN input

GND

Analog

Digital

2. Press the Bus key.

BUS

3. Press Bus from the bottom menu

and choose the LIN serial bus.

4. Press either Analog Source or Digital

Source to choose whether the

source for the LIN bus is analog or

digital.

Define Inputs

5. Press Define Inputs from the lower

menu.

6. From the side menu choose the

LIN input and the polarity of the

bus.