User Manual

MDO-2000A series User Manual
224
3. Choose a vertical unit by
toggling the Vertical
Units button to dBV
RMS, Linear RMS or dBm
using the variable knob.
Note
When the setting unit is dBm, connect a 50 Ohm feed
through termination on BNC.
4. You can define the scale of the
vertical axis by pressing on the
Unit/div button and using the
variable knob.
Range
1dB ~ 20dB (dBV RMS, dBm)
2mV ~ 1kV (Linear RMS)
5. You can define the zero level
position by pressing on the Position
button and using the variable knob.
Range
-12.00 ~ 12.00 Div
6. AWG fast switch button. This
button is used for user to observe
the AWG waveform change easily
in the spectrum after changing
waveform parameters.