User Manual

SWEEP (GRAPH MODE)

Setting output impedance

The output impedance can be set to 25Ω or 100Ω.

The varied signal source output impedance will lead to the varied

current or the difference of measuring value. If selecting <25Ω>,

then the voltage range is 10mV~1Vrms and the current range is

400µA~40mArms.

If need to compare test results with Keysight select 100Ω.

Steps

1. Press the Measure button to enter

[MEAS DISPLAY] page, and then

press the SWEEP function button on

the right side of the LCD to enter the

[SWEEP DISPLAY] page, and press

the Setup button to enter [SWEEP

MODE SETUP] page.

2. Use arrow keys to move the cursor

and select OUTPUT IMPEDANCE

item on the [SWEEP MODE SETUP]

page.

3. Use the numeric keypad to enter the time (ms).

Available

parameter

100Ω

Set output impedance to 100Ω

25Ω

Set output impedance to 25Ω