User Manual

LCR-8000 Series User Manual
124
Note
The open correction is quite sensitive to noise -
both noise originating externally and induced
noise. Therefore, if open correction fails, you
should check the following points before starting
the correction process again:
 Check that the test fixture or the test cables are
properly connected.
 Check that not any test piece is connected to
the test fixture or the test cables.
 During the correction process, be sure not to
disturb the fixture and the test cables or to
move your hand near them.
Open Circuit
 If the H/L test pole of the test fixture can be
adjusted, adjust the distance between the test
poles to the distance when measuring.