User manual

GSP-9300 Programming Manual
194
SYSTem Commands
:SYSTem:ALARm:STATe ................................................. 194
:SYSTem:CLOCk<n>:DATE .......................................... 195
:SYSTem:CLOCk<n>:MODE ........................................ 195
:SYSTem:CLOCk<n>:STATe ......................................... 196
:SYSTem:CLOCk<n>:TIME ........................................... 196
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess ....... 196
:SYSTem:COMMunicate:LANReset ............................... 197
:SYSTem:COMMunicate:SERial[:RECeive]:BAUD ...... 197
:SYSTem:COMMunicate:USB:MODE ........................... 197
:SYSTem:DATE ................................................................. 197
:SYSTem:ERRor:CLEar .................................................... 198
:SYSTem:ERRor[:NEXT]?................................................ 198
:SYSTem:KLOCk ............................................................... 198
:SYSTem:PRESet ................................................................ 198
:SYSTem:PRESet:TYPE ................................................... 199
:SYSTem:PRESet:USER:SAVE ....................................... 199
:SYSTem:REBoot ............................................................... 199
:SYSTem:SHUTdown ........................................................ 199
:SYSTem:TIME .................................................................. 199
:SYSTem:UPDate ............................................................... 200
:SYSTem:VERSion:HARDware? ..................................... 200
:SYSTem:VERSion:SOFTware? ....................................... 200
:SYSTem:ALARm:STATe
Set
Query
Description
Sets the system alarm output on/off.
Syntax
:SYSTem:ALARm:STATe {OFF|ON|0|1}
Query Syntax
:SYSTem:ALARm:STATe?
Parameter
0
Turn the alarm off.
1
Turn the alarm on.
OFF
Turn the alarm off.
ON
Turn the alarm off.
Return parameter
0
The alarm is off.
1
The alarm is on.