User Manual

OPERATION

6. A test can now be started, see page on 44 to get

started.

Initialize

7. Pressing the INIT key will initialize

all the channels to “X”, disabling

all the channels.

N I TI

Send

8. Pressing SEND will output the

channel settings onto the

connected scanner boxes.

E N DS

Note

If a number of terminals are turned on at the same

time, then the voltage/current that is set on the

safety tester must be divided by the number of

channels that are turned on for the test. For

example, if channels 1 to 3 are turned on for an

ACW test, then the test current must be divided by

3 to determine the result from each channel

(assuming identical DUTs).