User Manual

OPERATION

Automatic Tests

This section describes how to create, edit and run automatic tests.

Automatic tests allow you to link together up to 16 different

MANU tests and run them sequentially. Each stored MANU test is

used as a test step when creating an AUTO test.

 Choose/Recall an Automatic Test→ from page 81

 Edit Automatic Test Settings → from page 83

 Adding a Step to the Automatic Test → from page 84

 Creating an AUTO Test File Name → from page 85

 Saving and Exiting EDIT Status → from page 86

 Automatic Test Page View → from page 87

 Running an Automatic Test → from page 90

 Automatic Test Results → from page 94

Before operating the GPT-9000/9000A please read the safety

precautions as outlined in the Set Up chapter on page 23.

Choose/Recall an Automatic Test

Background

The tester must first be put into AUTO mode to

create or run automatic tests.

Up to 100 automatic tests can saved/recalled.

Steps

1. If the tester is in MANU mode,

press and hold the MANU/AUTO

key for three seconds. This will put

the tester into Auto mode.

The tester can only switch between

AUTO and MANU mode when in

the VIEW status.

MANU/AUTO