User manual

OPERATION
33
ACW, DCW and IR Testing
This section describes how to create, edit and run a single ACW,
DCW or IR safety test. Each setting described in this chapter only
applies to the selected test mode – For example the test time setting
for an ACW test is different to the DCW and IR test time settings.
 Setting the Test Function→ from page 34.
 Editing the Test Settings → from page 34.
 Setting the Upper and Lower Limits → from page 35.
 Setting the Test Time (Timer) → from page 37.
 Setting the ARC Mode → from page 39.
 Saving and Exiting EDIT Status→ from page 41.
 Setting the Test Voltage and Running a Test → from page 42.
 PASS/FAIL Test Judgments → from page 45.
 Auto Mode Testing → from page 49.
 PASS/FAIL Test Judgments for Auto Mode → from page 52.
Before operating the GPT-9600 please read the safety precautions as
outlined in the Set Up chapter on page 18.