User Manual

GOM-804 & GOM-805 User Manual

Configure Interface

Overview

The RS-232 and USB interfaces are standard for all

models, however the GPIB interface is only applicable

for the GOM-804G and GOM-805. The remote control

interfaces allow the GOM-804/805 to be programmed

for automatic testing.

For more information on remote control programming,

please see the Command Overview chapter on page 102.

Interface

USB

USB Device

RS-232

DB-9 male port

GPIB

24 pin female GPIB port (GOM-804G,

GOM-805 only)

Configure USB Interface

Background

The Type B USB port on the rear panel is used for

remote control. This interface creates a virtual COM port

when connected to a PC.

Note

The USB interface requires the USB driver to be

installed. See page 91 to install the USB driver.

1. Connect and

configure to

USB.

Configure the interface to USB in

System>Utility>Interface menu.

Page 71

Connect the Type A-B USB cable to the

rear panel USB B port on the

GOM-804/805.

Connect the other end to the Type A port

on the PC.