User Manual

GOM-804 & GOM-805 User Manual

3. Channel

setting

The Channel setting sets the number of DUT channels

that are used.

Use the arrow keys to navigate to the Channel setting and

press Enter.

Use the left and right arrow keys to select a digit. Use the

up and down arrow keys to edit the value of the selected

digit. Press Enter to confirm the setting.

Channel setting

Move

and edit

Select and

confirm

Enter

Channel Range:

01 ~100

4. Delay setting

The Delay setting adds a pause between each channel

measurement.

The Use the arrow keys to navigate to the Delay setting

and press Enter.

Use the left and right arrow keys to select a digit. Use the

up and down arrow keys to edit the value of the selected

digit. Press Enter to confirm the setting.

Delay setting

Move

and edit

Select and

confirm

Enter

Delay Range:

400ms ~ 30000ms

5. Start the scan.

Press the

Trigger

key or input a pulse signal on the

Trigger pin of the SCAN interface port to start a scan

test.

Note

See page 64 to set the external trigger edge as a rising or

falling leading edge.

The results will be displayed on the screen as each test is

performed. The results will also be output through the

scan port until the scan has finished.