User Manual

CONFIGURATION
119
Vertical View (Channel)
This section describes how to set the vertical scale, position, and
coupling mode.
Move Waveform Position Vertically
Panel operation
1. To move the waveform up or
down, turn the vertical position
knob for each channel.
2. As the waveform moves, the vertical position of
the cursor appears at the bottom half of the
display.
Reset Position
1. To reset the vertical position, press
the channel key for the signal.
2. Press Position. The position voltage
will reset to 0 volts/amps.
Run/Stop mode
The waveform can be moved vertically in both
Run and Stop mode.
Select Vertical Scale
Panel operation
To change the vertical scale, turn the
VOLTS/DIV knob; left (down) or
right (up).