User Manual

MEASUREMENT

Basic Measurement

This section describes the basic operations required in capturing

and viewing the input signal. For more detailed operations, see the

following chapters.

 Cursor Measurement → from page 77

 Configuration → from page 88

Before operating the oscilloscope, please see the Getting Started

chapter, page 11.

Channel Activation

Activate channel

To activate an input channel,

press a channel key.

When activated, the channel

key will light up. The

corresponding channel menu

will also appear.

Each channel is associated with the color shown

beside the VOLTS/DIV dial: CH1: yellow, CH2:

blue, CH3: pink and CH4: green.

When a channel is activated, it is shown above the

bottom menu system.

De-activate

channel

To de-activate a channel, press

the corresponding channel key

again. If the channel menu is

not open, press the channel key

twice (the first press shows the

Channel menu).