User Manual

APPENDIX
201
Holdoff range 10nS to 10S
Coupling AC,DC,LF rej. ,Hf rej. ,Noise rej.
Sensitivity DC ~ 50MHz Approx. 1div or 1.0mV
50MHz ~ 150MHz Approx. 1.5div or 15mV
150MHz ~ 350MHz Approx. 2div or 20mV
External
Trigger
Range ±15V
Sensitivity DC ~ 50MHz Approx. 1div~10mV
150MHz ~ 250MHz Approx. 150mV
250MHz ~ 350MHz Approx. 150mV
Input
Impedance
1M//15pF
Horizontal
Range 1ns/div ~ 100s/div (1-2-5 increments); ROLL :
100ms/div ~ 100s/div
Pre-trigger 10 div maximum
Post-trigger 1000 div
Accuracy
±20 ppm over any ؤ1 ms time interval
X-Y Mode X-Axis Input Channel 1;Channel 3
Y-Axis Input Channel 2;Channel 4
Phase Shift ±3° at 100kHz
Signal
Acquisition
Real Time
Sample Rate
5GSa/s (MAX)
150 & 250MHz 2CH: 2.5GSa/s
ET Sample
Rate
100GSa/s maximum for all models
Record Length 25k points
Acquisition
Mode
Normal, Average, Peak Detect, High Resolution,
Single
Peak
Detection
2nS (MAX)
Normal:Acquire sampled values.
Average:From2 to 256 waveforms included in
average.
Peak Detect:Captures glitches as narrow as 2 ns at
all sweep speeds
Hi Res:Real-time boxcar averaging reduces random
noise.
Cursors and
Measurement
Cursors Amplitude, Time, Gating available
Automatic
Measurement
28 sets: Vpp , Vamp , Vavg , Vrms , Vhi , Vlo , Vmax
, Vmin , Rise Preshoot/ Overshoot , Fall
Preshoot/Overshoot, Freq , Period , Rise Time , Fall
Time , Positive Width , Negative Width , Duty
Cycle, Phase, and eight different delay
measurements(FRR,FRF,FFR,FFF,LRR,LRF,LFR,LFF)
Cursors
measurement
Voltage difference between cursors ( V) Time
difference between cursors ( T)