User Manual

REMOTE CONTROL CONFIG
187
Configure GPIB Interface
To use GPIB, the optional GPIB to USB (GUG-001) adapter must be
used. The GPIB address can be configured for the GUG-001 from
the utility menu. See the GUG-001 user manual for more
information.
Configure GPIB
1. Insert the GUG-001 USB cable into
the rear panel USB device port.
2. Press the Utility key.
3. Press I/O from the bottom menu.
4. Press USB Device Port from the
side menu and choose Computer.
5. Press GPIB from the side menu.
6. Use the variable knob to set the
GPIB Address from the side menu.
Range
1 ~ 30
GPIB constraints
 Maximum 15 devices altogether, 20m cable
length, 2m between each device
 Unique address assigned to each device
 At least 2/3 of the devices turned On
 No loop or parallel connection