User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
89
LFR
Time between:
Source 1 first falling edge and
Source 2 last rising edge.
LFF
Time between:
Source 1 first falling edge and
Source 2 last falling edge.
Phase
The phase difference of two signals,
calculated in degrees.
360x
t2
t1
Viewing Automatic Measurements
Background
There are two different display options for
automatic measurements. A minimized and a
maximized view*.
The minimized view will display the real-time
measurement results.
The maximized view will display the real-time,
mean, minimum and maximum measurement
results.
Note
*The minimized view is only applicable in the
landscape viewing mode. The vertical viewing
mode displays automatic measurements in the
maximized view by default and will always be
displayed on screen.