User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
144
Second Method:
Vertical Orientation: Press and hold the DMM area for a short while to
directly bring up the multimeter settings.
Hold DMM
area
Multimeter settings
Horizontal Orientation: Press the Measure button to reveal the DMM
area*. Press and hold the DMM area for a few seconds to bring up the
multimeter settings.
*The DMM area can be expanded/collapsed by pressing once on the
DMM area.
Press the
Measure
button
Press and hold
DMM area
Multimeter settings