User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
109
Show Waveform in XY Mode
Background
The XY mode maps the input of channel 1 to
the input of channel 2. This mode is useful for
observing the phase relationship between
waveforms.
XY mode can also be used with cursors, see
page 83 to turn cursors on.
Connection
1. Connect channel 1 to
the X-axis source.
M
W
16.5pF
300Vrms MAX.
1
1 2
CAT 300V
CH2, Y-axis
CH1, X-axis
2. Connect channel 2 to
the Y-axis source.
3. Activate both channel 1 and
channel 2.
Page 41
Steps
1. From the Acquire menu toggle XY mode on.
1. The X-Y mode will appear.
Example
X-Y
waveform
X-Y cursor
measurements