User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
95
Steps
Press the Default icon from the Menu tray.
The default settings will be restored
immediately.
Panel Lock
Background
The panel lock can be used to prevent any
settings from being inadvertently changed.
Activate Panel
Lock
Press the Lock icon from the Menu tray.
The panel lock will appear at the bottom
of the screen.
Disable Panel
Lock
Press and hold the Padlock icon.
Wait for the progress bar to finish before
letting go
“Panel locked” will be displayed when
the screen is touched anywhere other
than the Padlock button.
Example
Press and hold
the Padlock
icon until the
green progress
bar is full.
Progress bar