User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
79
AC Priority
AC Priority mode will scale
the waveform to the screen
by removing any DC
component.
Steps
1. From the main display press the
Autoset key.
2. The waveform will appear on the display.
3. For a few seconds you will have the option to
press Undo? to undo the autoset
configuration.
Autoset Mode
1. Long press Autoset to bring up the Autoset
Mode menu.
2. Press the appropriate check-box to select Fit
Screen or AC Priority.
Note
The Autoset Mode menu can also be accessed via
the Utility menu, see page 103 for details.