User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
51
Entering the Vertical Menu
Steps
1. Press the vertical icon to bring up the vertical
menu.
2. The Vertical Menu appears.
Vertical Menu
Vertical icon
Channel or Reference/Math Waveform Selection and
Activation
Turning a
Channel On
From the vertical menu press the icon of the
desired channel, reference waveform or math
waveform to turn the channel on or to select the
channel as the active channel.
When activated the channel icon will be
colored.
The active channel will have an orange
ring around the channel icon.
Channels that are turned off will be
grayed-out.