User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Utility Commands
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Go_NoGo Commands
- Replay Commands
- Rotate Commands
- DMM Commands
- APPENDX
- INDEX
GDS-200 & GDS-300 Programming Manual
120
:GONogo:SOURce
Description
Sets the source for the Go/NoGo signal.
Syntax
:GONogo:SOURce {CH1|CH2|?}
Parameter/
Return Parameter
CH1~CH2
Example
:GONogo:SOURce CH1
Sets the source to CH1.
:GONogo:VIOLation
Description
Sets or returns actions for the Go/NoGo violations.
Syntax
:GONogo:VIOLation
{STOP|STOP_Beep|CONTinue|CONTINUE_Beep|?}
Parameter/
Return Parameter
STOP
The waveform will be frozen.
STOP_Beep
The waveform will be frozen and
a beep will be output.
CONTinue
Ignore the violation.
CONTINUE_Beep
Output a beep, but continue to
monitor the signal.
Example
:GONogo:VIOLation STOP
Sets violation action to STOP.
:GONogo:MODe
Description
Turns Go-NoGo on or off or returns its state.
Syntax
:GONogo:MODe {OFF | ON | ? }
Parameter/
Return Parameter
OFF
Turns Go-NoGo mode off
ON
Turns Go- NoGo mode on
Example
:GONogo:MODe ON
Turns Go-NoGo mode on.
Set
Query
Set
Query
Set
Query