User manual

GDS-200 & GDS-300 Programming Manual
118
Go_NoGo Commands
The GoNoGo function must be turned on(or use the command,
“:GONogo:FUNCtion”) before any of the Go_NoGo or Template
commands can be used.
:GONogo:CLEar ......................................................... 118
:GONogo:EXECute .................................................... 118
:GONogo:FUNCtion .................................................. 119
:GONogo:NGCount .................................................. 119
:GONogo:NGDefine .................................................. 119
:GONogo:SOURce .................................................... 120
:GONogo:VIOLation ................................................. 120
:GONogo:MODe ....................................................... 120
:TEMPlate:MODe ...................................................... 121
:TEMPlate:MAXimum ................................................ 121
:TEMPlate:MINimum ................................................ 121
:TEMPlate:POSition:MAXimum ................................ 122
:TEMPlate:POSition:MINimum ................................ 122
:TEMPlate:SAVe:MAXimum ...................................... 122
:TEMPlate:SAVe:MINimum ...................................... 123
:TEMPlate:TOLerance ................................................ 123
:TEMPlate:SAVe:AUTo............................................... 123
:GONogo:CLEar
Description
Clears the Go/NoGo counter.
Syntax
:GONogo:CLEar
:GONogo:EXECute
Description
Executes the Go/NoGo function or queries its
state.
Syntax
:GONogo:EXECute {OFF|ON|?}
Set
Set
Query