User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
99
Setting the System Date & Time
Background
The GDS-200/300 will keep the date and time
settings saved so long as the battery is not
allowed to fully discharged.
1. Press Utility>System>Date&Time.
The Date&Time menu will appear.
2. To set the date, press Date and use the number
picker to set the year, month and day.
3. To set the time, press Time and use the number
picker to set the hour and minute.
4. Press OK to save the date and time settings.
Note
The date and time settings only remain saved if
the battery is not fully drained. However, if the unit
shuts down due to insufficient battery power, there
will usually still be enough battery power to keep
the internal clock running for sometime.