User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
97
View System Information
Background
The system information displays the model
name, serial number, firmware version, FPGA
revision and GW Instek website address.
A QR code for the serial number is also
shown.
Steps
From the Utility menu, press System>System
Information.
System
information