User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
92
5. Select an automatic measurement from the
selected category.
Tip: Tapping the bottom of the selection
window will display the next group of
automatic measurements for the category.
6. To select the source for the selected automatic
measurement, long-press the measurement
selection. Select the source from the submenu
that appears.
Source
Measurement
selection
Measurement slots
Measurement
categories
Next
measurement
group
Automatic Measurement Options
Background
The Option menu will limit the bounds of the
automatic measurements to the entire record
length, to the screen graticule or to the onscreen
cursors. For measurement statistics, the mean
number of samples can also be set. The default
number of samples is set to 2.
Steps
1. Access the Measurement menu.
Page 90