User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
90
Steps
1. Press the M (Measure) icon in the menu bar at
the bottom of the display.
2. The minimized view will appear above the
menu bar.
3. To toggle between the minimized and
maximized view, tap anywhere within the area
that the automatic measurements are displayed.
4. To remove the automatic measurements from
the display*, press the M (Measure) icon again
in the menu bar.
Measure icon
Automatic measurement
area (minimized shown)
Selecting an Automatic Measurement
Background
Automatic measurements can be accessed from
the drop down menu or from the menu bar at
the bottom of the screen.