User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
74
Edge Trigger
Background
The Edge trigger allows you to acquire a
waveform on a rising or falling edge.
Setup
1. Press the Edge button.
Page 67
2. Press the Options icon to bring up the
Trigger options for the Edge trigger.
Edge Trigger
Return
Source
Coupling
Slope Rejection
Level
Holdoff
3. Select the appropriate parameters. See page 69
for a description of each parameter.
Source
CH1, CH2
Coupling
DC, AC
Slope
Rising, falling, either
Reject
Off, low frequency rejection, high
frequency rejection, noise rejection
Level
0.00V, TTL(1.4V), ECL(-1.3V), 50%
Holdoff
10ns - 10s