User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
57
Setup
1. Select the math channel by selecting
the M icon.
Page 51
2. Press the Options icon to bring up the math
settings.
Math waveform selected
Math settings
Math
1. Press the Math tab to reveal the math options.
2. From the Math tab select the sources and the
math operator.
Source 1
Operator
Source 2
CH1, CH2, Ref1, Ref2
+, - , ×, ÷
CH1, CH2, Ref1, Ref2
FFT
1. Press the FFT tab to reveal the FFT math
options.
2. From the FFT tab select the source, units and
FFT window function.
Source 1
Operator
Window
CH1, CH2, Ref1, Ref2
dBV RMS, Linear RMS
Hanning, Rectangular, Hamming,
Blackman