User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
56
Vertical Options – Reference Waveforms
Background
The Options menu in the Vertical menu allows
you to view the selected reference waveform
sample rate, record length and creation date.
Setup
1. Select a reference by tapping on the
corresponding R1 or R2 icon.
Page 51
2. Press the Options icon to bring up the
vertical options.
The data for the selected reference waveform
will be displayed.
Note
The reference waveforms can only be recalled if
they have been saved first.
Selected reference waveform
Reference
waveform
information
Vertical Options – Math
Background
When Math (M) is selected, the Options menu
in the Vertical menu allows you to set the math
mode, source operators, units and windowing
function.