User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
44
Set the Horizontal Position
Background
The touch screen can be used to conveniently set
the horizontal position.
Steps
Swipe the screen horizontally to set the horizontal
position of the displayed waveforms.
The horizontal indicator is a solid orange triangle
at the top to the grid.
The horizontal position (as a value) is shown at the
top of the grid.
The waveform will automatically snap to the zero
position at each crossing. To move past the zero
position, use the swipe gesture again.
Example
Horizontal
position indicator
Horizontal Position