User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
43
Set the Vertical Scale of the Selected Waveform
Background
The touch screen can be used to conveniently set
the vertical scale of the selected waveform. To set
other vertical scale options, see from page 53
Steps
Pinch in/out vertically to set the vertical scale of
the selected waveform.
A scale indicator will popup to show the current
scale in relation to full vertical scale range.
When the scale indicator appears, simply tapping
the upper or lower half of the screen will also
change the vertical scale.
The vertical scale (as a value) is shown in the
bottom left-hand side of the display.
Example
Scale Indicator
Vertical Scale