User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
32
7. The GDS-200/300 will now be recognized as a
virtual com port (VCP).
Tilting the Stand
Horizontal
To tilt the stand
horizontally, pull the
catch from the
smaller of the two
stands.
Pull this catch
Vertical
To tilt the stand
vertically, release the
catch from the larger
of the stands.
Pull
this
catch