User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
24
Run Mode
(Backward,
Run/Stop,
Forward, Single)
The Run/Stop key is used to start/stop
acquiring samples. The Forward/Backward
keys step backward/forward through each
consecutively sampled waveform. The Single
key puts the trigger into single mode.
Autoset
The Autoset function automatically configures
the panel settings to position the input signal
to the best viewing condition.