User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
20
BNC Panel
CH2 inputTapped holeCH1 input
M
W
16.5pF
300Vrms MAX.
1
1 2
CAT 300V
CH1, CH2 Inputs
Channel 1 and channel 2 BNC inputs.
Input impedance: 1MΩ
Input Capacitance: 16.5pF
Max voltage: 300V max (CAT II)
Tapped Hole
The tapped hole is used to secure the differential
probe option to the GDS-200/300. See the
differential probe manual for details.