User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
182
Sensitivity
DC - 25MHz: approx. 0.5div or 5mV
25MHz - 70/100/200MHz: approx. 1.5div or 15mV
Horizontal
Range
5ns-100s/Div (1-2-5 increments)
Roll
100ms/div - 100s/div
Pre-Trigger
10 div max.
Post-Trigger
1,000 div max (depend on time base)
Accuracy
±20ppm over any > 1ms time interval
X-Y Mode
Phase Shift
±3° at 100kHz
Cursors and Measurement
Cursors
Voltage difference between cursors(△V), time difference
between cursors(△T), frequency measure(1/△T)
Auto-measurement
36 sets
Auto-counter
6 digits. Range: 2Hz to rated bandwidth
Autoset
Available
Miscellaneous
Multi-language Menu
Available
On-line Help
Available
Time and Clock
Available
Battery
Battery Power
Li-polymer 6100mA/hr, 7.4V (Built-in)
Charge Time
2.0 hour (75%)
Operation Time
4.1 hours, depending on the operating conditions.
Probe Compensation
2V, 1kHz, 50% Duty cycle
Interface
USB
USB Device (Isolated)
Internal Flash Disk
120MB