User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
APPENDIX
173
APPENDIX
The Appendix contains basic maintenance, miscellaneous
information and the device specifications.
Firmware Update ............................................................ 175
Fuse Replacement .......................................................... 176
Resistor Standards ......................................................... 177
Resistor Standards .................................................................................................. 177
Standard Resistor Code ......................................................................................... 177
3 or 4 Digit SMD Resistor Standards .................................................................. 178
EIA-96 Code .......................................................................................................... 178
First Two Digits ....................................................................................... 178
Multiplier ................................................................................................... 179
2%, 5%, 10% Code ................................................................................................ 179
Multiplier ................................................................................................... 179
Last Two Digits ........................................................................................ 179
GDS-200/300 Default Settings ........................................ 180
GDS-200/300 Specifications ........................................... 181
Scope Specifications .............................................................................................. 181
Vertical ....................................................................................................... 181
Signal Acquisition ..................................................................................... 181
Trigger ........................................................................................................ 181
Horizontal ................................................................................................. 182
X-Y Mode .................................................................................................. 182
Cursors and Measurement ...................................................................... 182
Miscellaneous ............................................................................................ 182
Battery ........................................................................................................ 182
Probe Compensation ............................................................................... 182
Interface ..................................................................................................... 182
Display ....................................................................................................... 183
Power Adapter .......................................................................................... 183
Dimensions and Weight .......................................................................... 183