User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
164
REMOTE CONTROL
CONFIG
This chapter describes basic configuration for remote control. For a
command list, refer to the programming manual downloadable
from the GWInstek website, www.gwinstek.com
Interface Configuration .................................................. 165
Configure USB Interface ...................................................................................... 165
Remote Control Function Check ........................................................................ 166
Using Realterm to Establish a Remote Connection .......................................... 167