User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
152
Temperature Measurement
Back Ground
The GDS-300 can measure temperature using a
thermocouple. To measure temperature, the
DMM accepts a thermocouple input and
calculates the temperature from the voltage
fluctuation. The thermocouple type is taken
into consideration. Temperature measurement
is only supported on the GDS-300.
Note
Please see the specifications on page 184 for the
thermocouple specifications.
Connection
10A MAX
FUSED
V
W
COMA mA
GDS-220
Digital Storage Oscilloscope
200 MHz 1GSa/s
COM V
W
CAT II 600V
CAT III 300VFUSED
600mA MAX
Steps
1. From the multimeter settings choose the
temperature measurement.
Pressing the Temperature button will
toggle between ºC and ºF.
Temperature =
/
2. Next, select the thermocouple type.
Thermocouple = B E, J, K, N, R, S, T