User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
151
2. The selected mode will be previewed in the
lower corner.
Continuity key
Multimeter
settings
Preview screen
3. Press anywhere outside of the multimeter
settings area to return to the main display.
4. The approximate resistance will be displayed
when there is continuity present in the
connection.
OPEN will be displayed if continuity is not
present.
Example
Continuity result
DMM mode Hold on/off